Iron On Application Instructions: • Carefully remove the white backing • Position and press the design into the fabric. (The clear adhesive film will hold the design in place) • Always iron on a hard flat surface. • Set iron on medium or wool setting. (NO STEAM OR MOISTURE) Approximately 350 degrees is best for this process. • Place a piece of lightweight cloth over top of the design. • Use medium amount of pressure on the iron. DO NOT MOVE the iron back and forth, keep in on the pressing cloth for 30 seconds. (Heavier fabrics require more time, lighter fabrics require less time.) • Allow design to cool for approx. 2 minutes. Using care gently remove the clear plastic film away from garment. • Again, place lightweight cloth over top of the design and press of an additional 30 seconds. Tips: You may reposition design before ironing. If you move a crystal out of position, use a tweezer and carefully replace the crystal in it's original position. ONCE IRONED ON, the design is PERMANENT.